Ultraviolet Water Sterilization System for Whole House Water Purification system
More and more people have chosen to invest in their own water treatment systems to cope with the increasing potential dangers caused by water contaminants in private and municipal water sources.
Giardia, Cryptosporidium, and e.coli are considered to be the main microbe problem that are often found in private water sources, which could cause illness in humans. Most people are aware of e.coli, as it’s often discussed in media as a food contaminant, but it is also a water contaminant.
This water purification system is considered to be an effective equipment work on these problems. Not only provide better taste, but also provide additional insurance for your family health.
How it works?
How the sterilization system sterilize and purify the water kill microbe microorganism
The ultraviolet treatment process is an extremely quick physical process. Ultraviolet light mutates and/or degrades DNA. When the DNA is damaged, the organism becomes unable to function because its “instructions” are garbled or missing. An organism that has no instructions cannot function and reproduce, and cannot cause infection. It is rendered harmless and eventually dies.
In the disinfection process, water is purified as it runs through a stainless steel chamber (also called a “reactor”) that contains a special UVCA lamp. As the water flows past the lamp, the microbe in the water receive a lethal dose of healthy radiation.
The Water Purifier is a water treatment device that needs to be assembled, but it’s easy to finish. Each part of it have its own function, we will introduce them hereby:
Main Components Of The Water Steriliziation system.
stainless steel Reactor Chambe food grade 3/4'" MNPT inlet outlet
55w eletronic ballast controller power supply.
The chamber is made by 304 stainless steel, which was widely used in food industry, medical, considered to be stable and durable.
Length-22.8 inch, diameter-2.5 inch, inlet/outlet 1/2”, no requirement of the water flow direction.
lamp & Quartz sleeve
Quartz sleeve not only provide an interspace for the lamp, but also ensure high transmittance (90%) for the light.
Ultra strong lamp provide enough light to destroy the DHA of the microbe and bacteria.
Electronic ballast connect the lamp and the power (120V/60Hz), work as a controller in the system with 3.2 ft. (100cm) power cord and 3ft. (90cm) lamp cord.
Green light on ‘work’ means everything alright, red light blinks on ‘fault’ and the controller beeps when the system is failed.
Lamp Life About 365 Days.
The Water sterilization system kill destroy bacteria microoganism virus microbes
Environment-friendly safe sterilization process protect family drinking water healthy chemical free Go Green and Satey
Environment-friendly and safe sterilization treatment. Lack of chemicals means no harmful chemical byproducts are going back into the environment. And it avoid the potential threat residual chlorine, the taste of your water is not affected in any way as well.
Effective Sterilization kill 99.99% 4 log bacteria microoganism microbes virus Effective Sterilization
Water sterilizator ensure a 99.99% reducing of bacteria and microbe in the water. The corresponding light exposure is 30 mJ/cm². A slower flow rate, a higher wattage device or two sterilizer might be effective to handle a strong bacteria and microbe problem.
Easy installation and maintenance. No need for chemical supplement, the equipment is intended to be installed in the pipe system permanently. the lamp needs to be replaced annually and the quartz sleeve should be cleaned every 6-12 months,and replaced every 3 years.
Please CHECK YOUR BOOKLET in the package before you handle this system.
Make sure you read all important parameters before purchasing. Including the size of in/outlet, the size of the chamber, wattage, flow rate...
Water quality is extremely important for the optimum performance of the system. The following levels are recommended :
Iron < 0.3 ppm (0.3 mg/L)
Hardness< 7 gpg (120 mg/L)
Turbidity < 1 NTU
Manganese < 0.05 ppm (0.05 mg/L)
Tannins < 0.1 ppm (0.1 mg/L)
Water pressure & Air temperature
Maximum operating pressure 125 PSI (862kPa)
Minimum operating pressure 4 PSI (27.5kPa)
Maximum ambient air temperature 122°F(50°C)
Minimum ambient air temperature 32°F(0°C)
Hot Water Warning
The water in the chamber of this equipment can be very hot (Approx 140F) during an extended 4 hours of no water flowing. It's recommended to open the faucet until the hot water has been purged from the chamber. Keep human body away from the faucet during this time. Or install a 5 gallons water tank after the unit to reduce the temporary hot water.
The lamp: Replace the lamp annually (or biennially if seasonal home use) to ensure maximum disinfection.
Quartz Sleeve: Clean the quartz sleeve every 6-12 months, replace every 24 months. The coating on the quartz sleeve will slowly form due to the minerals in the water. This coating must be removed because it reduces the amount of radiation reaching the water, thereby reducing disinfection performance. If the sleeve can not be cleaned, it must be replaced.
We offer free Canada wide shipping on any order.
Shipping Policy Thank you for visiting and shopping at Healthy-life. Following are the terms and conditions that constitute our Shipping Policy. Canadian Shipping Policy Shipment processing times, All orders are processed within 1-3 business days. Orders are not shipped or delivered on weekends or holidays. If we are experiencing a high volume of orders, shipments may be delayed by a few days. Please allow additional days in transit for delivery. If there will be a significant delay in shipment of your order, we will contact you via email or telephone. Update this section if your processing time exceeds 10 business days. Shipping charges for your order will be calculated and displayed at checkout. Shipment method Estimated delivery time Shipment cost Canada post Standard 3-5 business days.